Standard Gate Motor

Ecogate motors can be attached to rotating blade or butterfly-style gate bodies, creating fully functional Standard and Smart Gates. Typically purchased as a replacement part.

 

Designed to work with Ecogate Standard Systems, which use the greenBOX 12 control unit, the Standard Motor uses a cost-effective 24V DC motor with limit switches.

Material: Zinc-plated metal (stainless-steel gates are available with Purchase Order)

Weight (Lb): 1.8 Lb (800 g)

Width (inch): 2.9" (73.4 mm)    
Height (inch):  3.5" (89 mm)    
Depth. (inch): 6.21" (157.8 mm)    

Installation: On Ecogate gates (4-16") using the two included M5x25 mm screws and facing the limit switch slot.

Motor Temperature Range: 14° F to 113° F (-10° C to 45° C); with Mobilgrease 28 the temperature range is from -40° F (-40° C).    
Ingress Protection (IP): IP51    

Required Maintenance: A properly installed motor does not require maintenance, but once per year it is recommended to test it using the greenBOX control unit.

Power Supply (phoenix type pluggable terminal): 24V DC, 0.1A (without pressure) - 0.9 A (under 27" w.c. pressure); power is consumed only when gate is opening/closing.

Indicators: Opening = Green LED; Closing = Red LED (indicators are active only when gate is opening or closing).

Motor Terminals: Pluggable screw terminals, [M1], [M2] for gate motor, [S], [-] (optionally [+]) for workstation activity sensor.

To Re-install New Motor

1. Check the position of the D-shaped shaft on the motor, and rotate it to match the position of the gear on the gate.
2. Install the motor shaft to the gear hole, and slightly rotate the motor until the D-shaft sits properly in the gear. Make sure to align the limit switch magnet to the rectangular slot on the gate.
3. Fix the motor to the gate body using the two included 8 mm hex screws.
4. Install the pressure reading hose to the barb fitting screwed on the gate. (Smart Gates).
5. Remember to test the gate.